GeorgiePorgie
PR Founding Father
How do I mitre this quarter round to fit nicely ?
It's 151 degree outside angle.
(180-151)/2=14.5 degrees.
Set the miter. Zipped the angles and I come up with this:
So then I just kinda eyed it up. Zipped some more off but then it's not flush. Angled piece at the bottom sticks out.
This is kind of frustrating.
I did good on crown molding. But I only had to make 45/90 inside outside cuts. What the hell am I doing wrong ?
I have a coping saw but not entirely sure if I understand the concept correctly on that. Draw a line. Cut at 45 degree angle. Then it lines up.
It's 151 degree outside angle.
(180-151)/2=14.5 degrees.
Set the miter. Zipped the angles and I come up with this:
So then I just kinda eyed it up. Zipped some more off but then it's not flush. Angled piece at the bottom sticks out.
This is kind of frustrating.
I did good on crown molding. But I only had to make 45/90 inside outside cuts. What the hell am I doing wrong ?
I have a coping saw but not entirely sure if I understand the concept correctly on that. Draw a line. Cut at 45 degree angle. Then it lines up.
